![]() ![]() Some people have found the easiest fix is to install a simple WiFi router or access point operating at 2.4Ghz to use for the iAqualink connection. FOR SALE Pentair Screen Logic Interface Protocol Adapter. Use the Guest network to keep an unsecured device off the main network. PENTAIR SCREENLOGIC INTERFACE Protocol Adapter P/N 520489 - 334.88. By using only one node the iAquaLink only saw one connection on each network. After the eero is "simplified" to a single node broadcasting on a single frequency - follow the normal reset procedures )turning the switch from Wired to Wireless and going into the network on a iphone and setting up the iAquaLink connection).Įero support's comment are that iAquaLink was seeing too many connections with the same ID (because of how the mesh works) and getting confused. ![]() ![]() ![]() Problems have been reported with iAqualink connecting to mesh routers like Eero.Ways to get a stable WIFi connection include assigning a fixed IP address to iAqualink, unplugging "extension" units (nodes) and setting the router to only broadcast 2.4 GHz. It is old technology.Ĭopied below is from the Jandy wiki but I think may apply to you. Some folks found they needed to give the ScreenLogic the old address block to get it to work. You didn’t answer my question about IP address ranges but my guess is you changed from a 192 address block to a 10 address block. The old WiFi firmware in pool systems has problems with it.Īlso folks have found they need to push the ScreenLogic rest button 3 times multiple times before it finally takes. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |